Can anyone tell me how to get more than five commands into a sequence (macro) on the harmony 720? I have several activities that I would like to assign to additional buttons but I cannot figure out how to get around the limitation of five commands per sequence.

Some say that if you have an old remote that has macros (like a one for all), you can have the harmony learn that macro and treat it as a single button command which you can then use as a single command in a sequence.

I was a little curious about this too so I did some searching and found this thread over on the RC board, Link (http://www.remotecentral.com/cgi-bin/mboard/rc-harmony/thread.cgi?keywords=6240&highlight=sequence) regarding more than 5 commands in a sequence using raw codes. I havent messed with the raw codes yet but it seems there is a way.

I tried setting up a couple of six command sequences but the 720 will only play the five native commands. I created two learned commands (select, select and Direction Down, Direction Down) but neither would execute. Other learned commands execute okay but the two or three click ones do not.