My Sony XBR910 has 6 Blinking lights

I have read you can fix this by replacing IC8002 and IC6501

Can someone give me a link on where to get these parts?

Thanks :)
I found the chips


how do you remove the d-board?

it has 4 things connecting the d-board to the a-board



i dont want to break it
http://img399.imageshack.us/my.php?image=dsc00547kk4.jpg

http://img399.imageshack.us/img399/5758/dsc00547kk4.jpg

Go register on this site below and submit your questions in the troubleshooting section of the site. There are several retired Sony engineers that reside on this forum and they can answer just about any question you have.

http://www.agoraquest.com/index.php

Regards, Silverfox1

Those two connectors should just pop out with a little force. The metallic board to board jumpers are captured in the rectangular black plastic piece which unplugs from the receptacle on the board. The difficult connections are on the flyback transformer. They can be damaged very easily.

Many owner's have repaired the D-board without actually removing the board itself. The bottom section of the set, with most of the boards, can be slide out and rotated 90deg to a service position. This will give you easy access to the bottom of the board. I believe a small amount of plastic under the board will need to be removed to gain clear access to both ICs. Check out thread (http://www.avsforum.com/avs-vb/showthread.php?t=928945) if you haven't already. It has good information.