HI. when running projector for about a hour, the keystn gets way out of aligment . When I try to see if I can correct it ,I get a message "D CONV CPU NOT READY" has any one had this problem. I have two nec 1352. I changed the SYS, D-CON , WAVE, OSC, boards. That didnt help. Could it be in the F Drive? Thanks in advance for any suggestions.

You may want to ask the question at

http://www.curtpalme.com

Doug, Curt & Mark_AW monitor that site more then here anymore.

Thank!
Mike

That's a new one on me frankly. Since you have two sets, just keep swapping boards until you find it. Try the H deflection board, convergence output, etc. I can repair whatever board is defective.

It's not the F drive.

You've tried all the boards I'd guess would be the issue.

Try the H-Deflection board and the C-drive, like Curt said.

If that's not it....could it be a bad connection or a bad track/joint on the main motherboard?

Mark, I will give it a try this weekend. Thanks .