Good Afternoon,

I'm hanging a new plasma in my master bedroom, and need to purchase a mounting bracket. I'm in the middle of painting the room (and doing drywall repairs :( )

I want to get the bracket lined up and in place BEFORE I paint the wall, so I can get the bracket, AC, and AV jack boxes cut in and aligned properly.

I'm not sure which set I'm going with, either the Panasonic 65" or Pioneer 60", but I'd like to get the bracket now and get the pre-installation work completed.

I don't need a bracket that allows moving the set away from the wall (but if it does, so be it), but I'd like one that allows vertical angle adjustment, and is well made. I don't mind spending a few extra $ to get something halfway decent cosidering the investment in the panel.

I've seen a few with cutouts for the electrical and AV cable wall boxes. That would be nice and clean...

Recommedations? Are the two sets referenced above that different in bolt patterns that I'll need to decide on the plasma panel before the bracket?

Thanks

Try Monoprice, forum sponser, link at the top of the page. Good quality mounts, great service, and low prices.

I'm actually looking for product recommendations more than sellers, but I'll be sure to check them out once I determine which mount is best.

Thanks for the reply.

Be sure to check on what mounts work with your plasma. I had a Panasonic 58PX600U before and when I sold it and upgraded to my Pioneer 6010 I had to sell my mount and get a different one as the holes were about 3 inches further apart on the Pioneer. Go figure.