I posted this on another site with no answers so here we go.

Perhaps someone here can help me understand the Lumagen memory system.
I have selected Independent memories and am able to store memories for my currently used inputs. I have two separate configs for Input 1. One which outputs 1080i/72 for 1080i/60 input and one which outputs 960/60 when it senses a 480i input.
I have two separate configs for input 2. One which outputs 1080i/72 for 1080i/60 input and one which outputs 817/60 when it senses a 1080/24 input.
This all works fine and is all linked to memA on both Input 1 and 2.
What I don’t understand is how to properly use the memA, MemB, MemC, MemD memories. By reading the instructions it looks like if I select input 1 then press memA and then calibrate and save this should stay in MemA. This seems to work but when I do the same for MemB it overwrites what I had done on MemA. Now MemA and MemB are the same.
Can someone give me some guidance on the proper way to use Mem A,B,C,D? I have read the manual over and can’t seem to make it work.

Thanks
Steve

What is it that you want to make different on memb compared to mema?

We have technical tips posted on our website that explain the user memories, complete with diagrams. Which model Lumagen do you have?

http://www.lumagen.com/testindex.php?module=manuals

Best regards,
Randy Freeman

We have technical tips posted on our website that explain the user memories, complete with diagrams. Which model Lumagen do you have?

http://www.lumagen.com/testindex.php?module=manuals

Best regards,
Randy Freeman

Randy
Thanks for the tip.
I have the Vision DVI.
I knew about the manuals but never browsed down and looked at the tech tips. I'll take a little time to browse them. If I still can not fig it out I'll post again.

Steve