Hey guys

I finally got a projector. And it was working well untill I tried changing the spacers between the crt and frame.

After chnaging them the red will show an image but it will look very foggy and it is nowhere near bright enough to be viewable on the screen. And also the red cut off will still make the image disappear(I'm looking into the lens wild doing all this)

I suppose the CRT did move a fair bit when I did the spacer changing. And I've already opened it up further to see if any connections came loose. None were obviously loose and I worked all of them slightly. No improvement. Any other connections to check??Work them again??

No error codes have shown up. Except for c3 with blinks momentarily as you turn it off.

PLEASE HELP ME FIGURE THIS OUT!

Rudy

The only other thing I noticed is the horizontal lines on the face.

And when I tap the crt it will sort of flicker but it wont get bright?

I can't even beleive this is happening.

Ha ha ha Turned out it was just a cable pulled out of its socket.

That took a load off me.

And here I am now posting on AVS on my wall :D
Cheers,
Rudy