Since my Samsung BD-P1400 BD-player can`t decode DTS-MA I moved the RadianceXD after the preamp (between preamp and projector) instead of between the BD-player and pramp. But I get no picture. The preamp is a Onkyo PR-SC885, which HDMI inputs is setup to "through". I get no OSD from the preamp either, though I have not been able to get this over HDMI at all.

The RadianceXD is setup to output video only on HDMI out-1, and audio only on HDMI-2.

I also notice something strange/annoying that maybe could be related when turning on my HTPC, which is also connected to the RadianceXD. When the boot process comes to the screen where you can choose OS the screen usually turns black, and stays black. If I disconnect the DVI-cable from the PC, and connect an CRT-monitor to the analog output on the HTPC and reboots, the picture is shown on the CRT-monitor, and Vista boots as normal. I can now reconnect the DVI cable, and setup Vista to use the monitor on the DVI output. Strange..

Is there a setting in the RadianceXD inputs that can cause this?

Gunnar

Seems that the prolem is the Onkyo PR-SC885. No picture even when connecting directly to the Onkyo.Tried different cables, but nothing..

Gunnar

I have the same setup as far as equipment positioning is concerned. I have the Vision instead. I had to play with the EDID output, but I think that has to do with DVI. Have you tried hooking up the Radiance directly to the projector, skipping the Onkyo. I would also remove the Radiance from the loop and see if you get a picture, thus identifying how far your signal is making it. I would assume you had the Onkyo's HDMI output enabled, right?
Also, what projector do you have?

Since my Samsung BD-P1400 BD-player can`t decode DTS-MA I moved the RadianceXD after the preamp (between preamp and projector) instead of between the BD-player and pramp. But I get no picture. The preamp is a Onkyo PR-SC885, which HDMI inputs is setup to "through". I get no OSD from the preamp either, though I have not been able to get this over HDMI at all.

The RadianceXD is setup to output video only on HDMI out-1, and audio only on HDMI-2.

I also notice something strange/annoying that maybe could be related when turning on my HTPC, which is also connected to the RadianceXD. When the boot process comes to the screen where you can choose OS the screen usually turns black, and stays black. If I disconnect the DVI-cable from the PC, and connect an CRT-monitor to the analog output on the HTPC and reboots, the picture is shown on the CRT-monitor, and Vista boots as normal. I can now reconnect the DVI cable, and setup Vista to use the monitor on the DVI output. Strange..

Is there a setting in the RadianceXD inputs that can cause this?

Gunnar

What have you connected to the Radiance on the output side ?