Ok, I have two DirecTV units in one room. I have reset and cleared and reset the DirecTV remotes till I am blue in the face. My thinking was to clear one D* remote and set it to AV1 or 2, and then teach my Harmony One remote that IR code to control two separate D* boxes. Leaving one remote stock, of course.

What do I need to do to make this work before I throw something through the window. I have followed the D* on screen instructions to a T with the remotes and wind up with one remote that works on either selection, AV1, 2 and D*. I have tried different codes, etc, nothing works. Help me out here.

Check out THIS (http://www.avsforum.com/avs-vb/showthread.php?t=1140922)thread. There is already an upgrade (or whatever logitech calls it) for a 2nd D* receiver in their database "HR20-700S3" (works for all HR2x's). HERE's (http://www.dbstalk.com/showthread.php?t=79330)a good thread about that, and ANOTHER (http://www.dbstalk.com/showthread.php?p=2001180#post2001180)good thread about setting D* receivers to different codes.

Check out THIS (http://www.avsforum.com/avs-vb/showthread.php?t=1140922)thread. There is already an upgrade (or whatever logitech calls it) for a 2nd D* receiver in their database "HR20-700S3" (works for all HR2x's). HERE's (http://www.dbstalk.com/showthread.php?t=79330)a good thread about that, and ANOTHER (http://www.dbstalk.com/showthread.php?p=2001180#post2001180)good thread about setting D* receivers to different codes.

Thank you VERY MUCH! I was starting to feel like an idiot screwing with this.