My Paradigm PW 2200 recently had it's amp checked and driver replaced.
Used to run it at 50% gain and 50% FQ (with Paradigm Monitor 7s)

Now I have to leave the FQ (no #s on it) at 25% or I get pretty bad distortion. It sounds fine and the Monitors go down far enough do it sounds OK, but I am wondering what is going on?

Any advice would be appreciated!

regards,
Red

My Paradigm PW 2200 recently had it's amp checked and driver replaced.
Used to run it at 50% gain and 50% FQ (with Paradigm Monitor 7s)

Now I have to leave the FQ (no #s on it) at 25% or I get pretty bad distortion. It sounds fine and the Monitors go down far enough do it sounds OK, but I am wondering what is going on?

Any advice would be appreciated!

regards,
Red


I guess I sure worded that poorly! It used to be set (at the sub) for about 120hz, now it distorts badly at anything over 40hz. Volume has no effect.

regards,
Red