LaRazaUnida
01-04-07, 02:04 PM
Hi guys...I am in a bit of a bind.
I am nearing the completion of my sonosub project but now am at a problem on where to put the thing.
It is for my parents but there is literally no where to put it...well almost no where..
Here is a picture of the layout.
http://img465.imageshack.us/img465/9854/roomlayoutom0.th.png (http://img465.imageshack.us/my.php?image=roomlayoutom0.png)
The only place that I can see where the 5ft 5in sonosub can go is laying down behind the tv and 2 JBL E100s with its baseboard shooting towards the wall where the current sub is. Would I lose a lot of db and add bouncy frequencies?
If I did that, would I build something or put pegs to level it out and keep it from rolling around?
The only other option is to put the project on hold and get a klipsch RW-12d. Thing is that I can finish the project for a little bit less than the klipsch from a friend and I was assuming the output would be better with my DIY 15"dvc and 300watt bashamp.
Suggestions??
Thanks guys!
EDIT"
One more thing. In hooking up the sub, which method is hooking up the wires parallel? http://www.crutchfieldadvisor.com/learningcenter/car/subwoofers_wiring.html?subs=1&impedance=DVC4x2
Would I connect it according to option 1 to achieve a 4ohm load? Thanks a lot!
I am nearing the completion of my sonosub project but now am at a problem on where to put the thing.
It is for my parents but there is literally no where to put it...well almost no where..
Here is a picture of the layout.
http://img465.imageshack.us/img465/9854/roomlayoutom0.th.png (http://img465.imageshack.us/my.php?image=roomlayoutom0.png)
The only place that I can see where the 5ft 5in sonosub can go is laying down behind the tv and 2 JBL E100s with its baseboard shooting towards the wall where the current sub is. Would I lose a lot of db and add bouncy frequencies?
If I did that, would I build something or put pegs to level it out and keep it from rolling around?
The only other option is to put the project on hold and get a klipsch RW-12d. Thing is that I can finish the project for a little bit less than the klipsch from a friend and I was assuming the output would be better with my DIY 15"dvc and 300watt bashamp.
Suggestions??
Thanks guys!
EDIT"
One more thing. In hooking up the sub, which method is hooking up the wires parallel? http://www.crutchfieldadvisor.com/learningcenter/car/subwoofers_wiring.html?subs=1&impedance=DVC4x2
Would I connect it according to option 1 to achieve a 4ohm load? Thanks a lot!