I was messin around online reading up on the service menu and was in there on my Z2 changing some things around and lost my default settings on 3 of them. I have firmwire 107 .. If anyone with a Z2 has the 107 fw could look it up for me please that would be great. I want to know what the vaules of 13,14,15 are. You can get into it by pressing menu + input on the projector or by holding down menu on the remote for awhile.

The only problem will be that every Z2 has different settings. Somehow in Sanyo's infinate wisdom they created a product where no two Z2 units have the same settings. They calibrate each projector manually before they leave the factory. According to the service manual 13,14,15 all have a "initial" value of 95 and 13,14,15 are the "red, green and blue common center adjustments". My Z2 is connected through the DVI input and 13=101,14=107,15=98. Every input has different values so if you tell me which input you messed them up on I'll give you mine.

Well tell me your settings for both. When i changed them i cannot believe i didn't write em down but man i know that one was 90, anohter was 79 and another was 84. I just dont know what one was what. I think i did it on DVI and not component. I should check my component one to see if its any different though I never thought of it. I can't believe u cant reset it to what it came with on the service menu. so for now we will go with DVI... I will have to check later to tell u waht the components are set at .