I have a TAW HD800 PJ, which I am told is a modified Marquee 8110.

I have the RECALL memories setup as follows:

1) Memory 01 setup for 60Hz... my Directv STB input
2) Memory 02 setup for 72Hz.. My Rock Pro (video processor) DVD input

Once upon a time, the PJ would automatically switch to the appropriate memory as the scan rate changed... Now it only automatically switches to Recall 01, when I change to the 60Hz input signal.....

Whenever I change to a 72Hz input, I have to manually recall Memory 02.

Any suggestions on how I regain the auto switching feature for BOTH 60 an 72?

Hello

Go into UTIL, 1 and activate ASR if not already.

Thanks Tim...

It was the ASR... it was NOT turned on for R02, it was quite odd... when looking at Util,1 for R02 it showed ASR on.... but when I looked at UTIL,3, only R01 was checked?

I found it quite painfull getting it turned on for R02.... Sometimes making adjustments to this PJ is quite quirky

I figured it would be as simple as unlocking R02... turning ASR on... copying R02 to R02... then locking R02 again..

I ended up playing around for at least 10 minutes (during which time even R01 recall stopped working)... anyway... it all works now...

During this playing around, I noticed (from UTIL,3) that I have at least 10 recall memories.... I use only 2 (and now both have ASR on).... Is there a way to delete the othere recall memories?

Thanks again