I finally got deeper into the setup on my PJ yesterday and have a few questions. The manual says to setup the last line of the cross hair pattern 15 to 20 mm from the screen edges. I have a 16x9 screen and when I do this the top and bottom of the picture is cut off. Do I just need to adjust the vertical sizing out to recoup this lost picture? I wanted to check before changing any settings and messing up the couple of hours I already have into it. Also the manual says to hold down the memory key for 5 seconds to save the setting as the standard data. When I do this the memory is saved but I do not get the menu asking if I want this registration data to be used as the standard for all inputs. Any ideas on this?
Thanks
Dan

as far as the memory issue goes I had the same issue. The solution... Use the memory key on the projector and it may take longer than 5 seconds. this is the only way I've gotten that to work.