I tried to get my projector hooked up to my computer the other day, never did get it to show a pic. but now i have a prob with the blue jumping out of convergance. It always takes place in the same area. I do a convergance and then when i turn it on the next day it is out of wack in the same spots but in the oppisite direction that it was the day before. What did i mess up when i hooked it to my computer? thanks in advance for any help

CHances are your Dallas chip is bad. If you can still get one, change it and I'm sure it will be fine.

ok i think i know what to look for...are they the same as they were in old computers (they were used for cmos backup) but where do i look for it in the projector?

also any ideas why it happened after tring to set it up to my computer? I really would like to get it to work with my computer but i am alittle afraid to try again..lol

Check out the tips section of my site below. It's labelled in the ECP section..

curt would that also cause the blue to jump around on convergance and other wise?