Please post up what HDMI sources that you have that work. Also let us know what display you have and if the signal is looped through anything else.

I've got a Sony 51" CRT HDTV with DVI connected to a comcast 6412 with HDMI. I've lost the video signal twice in 2 months but power cycling the cable box fixed it.

Oppo970 into Sanyo PLV-Z5, short cable run and no audio over HDMI.

Not exactly a tough case which is no doubt why it works.

=)

That said, the amount of time it takes the PLV-Z5 to figure out that it is receiving an HDMI signal (or that it has lost it) sucks. It's freaking 2007 - this stuff should be near instant!

Cheers

Mine works fine! Cheap RCA DVD player to Zenith 50" plasma TV. TV detected it when hooked up and turned on, and never skipped a beat.

Scientific Atlantic 8300HD cable box connected with about 6 feet of HDMI to a Yamaha RXV2700. Then 50 feet of HDMI from the Yamaha to a Panasonic TH 50PX600U. Everything works great. No speckles, no signal problems.

I have the Monoprice 5x1 HDMI switch and am using it successfully with three sources: a Marantz 9500 universal player, a Toshiba HD-XA-2 HD DVD player, and a Scientific Atlanta 8300 HD set-top box. My display(s) are a Panasonic 900 front projector, and a Westinghouse 27" LCD tv.

I can switch between sources while watching with no problem. However....I did have a problem losing the HDMI "hand shake" when I was using this switcher with my original HD DVD player, the Toshiba HD A-1. Apparently the newer XA-2 player made all the difference!

Xbox Elite
PS3
A1
Cable Box

(all with blue jeans .5 Meter HDMI)---> DVDO HDMI Switcher--->Fujitsu 50"




All is working fine not a single issue. At present I am only using HDMI for video. Hope all stays ok when I get a new SSP and use HDMI for video and audio.

PS3 straight into a Sony 46" XBR2 LCD. I can get 1080p, no problems.

i can also run it inot a 32" Philips LCD up to 1080i (panel's max)

i have a receiver on the way so i'll edit this when it gets here.

I use a Toshiba XA1 to my Runco VX1000ci projector without any problems - 1080i output

Hello:

After all the things I read here it seems I got lucky....

SA 8300HD and PS3 into my Denon 4306 via HDMI

XBOX 360 into my Denon 4306 via the XBOX component cable

DENON out to my Pioneer 940HD via HDMI.

No issues.

Splotto

SA 8300HD and Denon DVD-3910 both send signals through HDMI to Denon AVR-4306. And then it goes through HDMI to Pioneer 4340HD plasma (1080i) - no issues.

Hope all stays ok when I get a new SSP and use HDMI for video and audio.
From your lips to God's ears!

For all of you SA 8300 users, what cable system and software (Passport/Sara/Navigator).

My 8300 didn't work properly with HDMI when I tried it last fall, wondering if they've finally fixed the firmware?

For all of you SA 8300 users, what cable system and software (Passport/Sara/Navigator).

My 8300 didn't work properly with HDMI when I tried it last fall, wondering if they've finally fixed the firmware?

Hello:

Brighthouse Cable (Orlando) and Passport S/W.

Splotto