KrisRoberts
05-20-07, 06:50 PM
I just discovered that the MG Focus values for the off center zones have not propagated with the other settings from the resolution in which I did the adjustments.
The center/all values for the MG Focus do appear to be the same on all the memories, but if I go to the various positions off center they are all 128 except on the memory where I set it up.
I've tried a bunch of stuff to get them to transfer to the other memories, but so far nothing has worked.
Once I did the focus, I saved the values as the 'service data'. When I go to another input and tell it to reset to the service data it does - and everything looks pretty good. The main focus and registration values all appear to be the same. But my corner focus is off and when I go into the MG Focus banks for the off center areas they're all 128.
Is this by design?!? Am I really supposed to get all the other focus and registration values to propagate but go in and enter the focus stuff by hand (or re-do the adjustments) for each input?
The center/all values for the MG Focus do appear to be the same on all the memories, but if I go to the various positions off center they are all 128 except on the memory where I set it up.
I've tried a bunch of stuff to get them to transfer to the other memories, but so far nothing has worked.
Once I did the focus, I saved the values as the 'service data'. When I go to another input and tell it to reset to the service data it does - and everything looks pretty good. The main focus and registration values all appear to be the same. But my corner focus is off and when I go into the MG Focus banks for the off center areas they're all 128.
Is this by design?!? Am I really supposed to get all the other focus and registration values to propagate but go in and enter the focus stuff by hand (or re-do the adjustments) for each input?