I am doing all my video switching through my A/V receiver, so there is no need to have the Harmony try to switch inputs on my TV. Is there a way to disable the step where it attempts to switch the TV input?

I tried deleting all of the inputs from the device settings on the TV, but then it tries to force me into a channel change instead, which creates a different problem.

Anyone had any luck with this? I saw this question on the 880 main thread, but it hasn't gotten a response.

I don't understand the problem. There is a setting in the software wizard which asks what input to use for the TV and receiver. Your TV input will be the same for each device and your receiver will vary. Did you set it up this way?

My receiver does my switching as well and I don't have any issues.

I don't understand the problem. There is a setting in the software wizard which asks what input to use for the TV and receiver. Your TV input will be the same for each device and your receiver will vary. Did you set it up this way?

My receiver does my switching as well and I don't have any issues.

There are no issues per se, but I noticed that even though the input isn't changed, the input menu on the TV is invoked as if it were doing an input change. I'd like to avoid that part, since essentially nothing is being done. It might save me 100 ms, which isn't much, but it's something.