How modify the neckboard R762721 for the use with the Mec (Panasonic) tube?

http://decibel.altervista.org/_altervista_ht/neckboard_th.jpg (http://decibel.altervista.org/_altervista_ht/neckboard.jpg) http://decibel.altervista.org/_altervista_ht/neckboard_front_th.jpg (http://decibel.altervista.org/_altervista_ht/neckboard_front.jpg) http://decibel.altervista.org/_altervista_ht/neckboard_retro_th.jpg (http://decibel.altervista.org/_altervista_ht/neckboard_retro.jpg)

Thanks

Use Panasonic neck cards instead.

Use Panasonic neck cards instead.

do you have someone? :p

Say hello to my little friends :D .

Say hello to my little friends :D .

HELLO!!!

(in PM) :D

Ok i am intereseted. But what are the exact benefits of these neckboard over the stock ones with d808s?

These are the higher 120Mhz bandwidth and so will help with a sharper picture.

As well, If you are trying to change from Sony to MEC tubes then these really are a must.

Ok i am intereseted. But what are the exact benefits of these neckboard over the stock ones with d808s?

Honestly the difference between the 75 MHz boards and the 120 MHz board is pretty minimal with one exception. If you don't see the smearing that some 75 MHz boards exhibit then you will see little or no difference between the two other than on test patterns. I have a complete set of the 120 MHz boards and I tried them in my Data 808s and they were a marginal improvement (I don't have the smearing on the 75 MHz boards). In fact I had another issue with the 120 MHz boards (unstable raster brightness) that I went back to the 75 MHz boards and have never looked back. The P16s were a much better upgrade. Of course if you have smearing/streaking then the 120 MHz boards will solve that perfectly.