Hi all,

When I go into the G2 adjust site in the service menu, the 3 green led's on the neckboards doesn't turn off. So according to the manual, they need to be adjusted. But I'm quite happy with the image from the projector, so should I just leave G2 where it is, or will it definitely give me a better PQ by adjusting them?

Thanks, Morten.

Move them VERY slowly, I mean very slowly.

Just turn you wrist from full one way to the other and take about 20-30 seconds to do this - Practice sitting at you PC reading this, thats about the speed to go at, you can go faster but most people then come back and post that they could not find the correct position as they have gone too fast.

The correct position is very easy to miss if you are not used to this.

You will get a much better picture if you combine the correct G2 setting and then colour balance the PJ.

Just correct G2 will be better.

I'll try that, thanks.

Morten.