Hello,

Welp, I'm gonna say right off the bat that I'm out of luck here. My RCA 52" rear projection tv has a warped screen. It is almost like the convergence was just completely thrown off. Adjusting the convergence on the menu function is not enough to align the colors, however when I take off the back and do it manually, it somewhat works. That is not the most serious part of the problem though. The entire screen is warped around the edges. It was completely fine one second, then the next time I turned it on, it was completely out of whack. There were never any previous indications of this problem. I had two speakers next to the TV, which never caused any problems, but I'm not sure if the magnets could have caused this. I move them, but still had the same problem.

If anyone has any suggestions, I would greatly appreciate it. Thanks in advance.

If it is fine one second and then it is bad it appears to be a faulty electronic component not a warped screen.

It was fine, then warped. It does not go back in forth. I meant that the switch was instantaneous. I never had any indication that something was wrong with it. It was just all the sudden warped.

That isn't because of convergence...it is a geometry issue...

Ok, I've got into the service menu. Now to just find what it all mean....... Yeah, sorry, I'm a noob, and probably shouldn't even be in the service menu.

Make sure you write down ALL values BEFORE you start changing #'s!!!