Using spyder TV pro I calibrated my wd-65831 yesterday. This only the second time I've claibrated it and I couldn't get the cuts value on the red to change. The value was within spec but this time I wanted all of the values to read 100%. I could get the gains values to adjust but not the cuts. I don't remember adusting the cuts the first time so I don't know if this is a new problem or operator error. BTW, the picture has always been great but calibating it makes it look even better.

Any help is apreciated.

Rob

which parameters are you using..remember sometimes you have to adjust other colors to bring the other ones up..its a teeter totter move..

GGL
GRL
GBL
Are the cuts

GGH
GRH
GBH

Are the gains

I found documentation where I did adjust the cuts on my first calibration. I just cant figure out how to make the values change now. I had no problem making the gains value change by pressing the up and down arrows. It should work the same on the cut value. Maybe there are some limits in the firmware that keep you from making adjustments when other values are within specific ranges?

Rob

Anyone else have infomation on cuts and gains adjustmnet?

Rob

Rob
The ones with H are for the HIGH temperature when your in the regular user menu (low or High), the other one with the L is for LOW..so - you actually have it incorrect using them both for calibrating..

CMG, CMR, and CMB for the low end of the gray scale and the GGL GRL GBL and for the highend of the greyscale..Please note, this is the the LOW temperature in the user menu.