Hi

Does somebody have Barco projector control software for Dos ?


regards


Thierry

Message sent

Is this what your looking for ?

http://www.cineversum.com/downloads/tde/BSP/Manuals/UserGuide/R5975014_04_userguide.pdf

Tom.W

Sorry my english is poor!

Yes it's this Dos software I need.

I've BR909 controler problem, all remote control are locked.
I want to activate them with RS232; at LOCK_IR adress 50H, command Dat1 = FFH

Is there Somebody who knowing how the protocol functions?

regards

rs232 (serial) is pretty simple - as long as you have the baud rate and parity correct at both ends it should "just work"

Not many PCs have serial anymore but you can get USB->9 pin D converters

Good luck

Are you sure the remote is working and set to projector address 0 ? Or are you saying it requires a passcode ???

Tom.W

The remote who is on the barco does not works also.

There is no code accès.

Read this,

Q: My Barco remote has stopped working, what has happened?

A: If it happened after you changed the battery (or removed the battery), the remote needs to be set-up to control the projector. The Barco remotes can control multiple projectors in a chain using addresses. The projector can be set to respond to a certain address only, using the dip switch's on the controller, what has been set does not matter as all projectors will respond to address 000. On the remote between the Adjust and Standby buttons is a recessed button you can press with a pen, press it and then press the 0 digit on the remote. The remote is now set to projector address 000 and the projector will now respond regardless to the actual address its set to. Alternately you can press the recessed button on the remote while aimed at the projector or screen and the projector will display its address (or bring up the Barco information screen from the menu to view the address), then proceed by pressing those numbers in sequence on the remote i.e. if the projector displays address 025 press 0 then 2 then 5 on the remote and it will be set to control a projector with that address, either way the remote will work again.


And this..

http://www.crtprojectors.co.uk/barco_faq.htm#Q:%20My%20Barco%20remote%20has%20stopped%20wor king,%20what%20has%20happened?

Also delete all existing blocks and start over ...

Problem solved, :)
it was a lock of IR, not need Barco programs, we need direct access to RS232, and then send the protocol Barco adapted to the machine.

But others problems see

http://www.cinetson.org/phpBB2/viewtopic.php?t=23689

Regards

Thierry