Hi, I'm having a problem. My Panny's HDMI Cable going directly into my Onkyo 605 receiver has no video. I then installed the HDMI directly into my cable box instead, and ran the audio cable thru the Receiver and it works. But now I have to switch the HDMI cable from the cable box to the DVD by hand when I want to watch a movie.

Is there a switcher I can buy so that I can run my DVD & Cable Box without having to switch the HDMI cable from one to the other, when I want to watch my DVD?

Thanks!

see monoprice.com

Actually, i just spoke to a customer service rep and they weren't a lot of help. Seems like I need to figure out why the HDMI will not work going directly into the Receiver.

My Panny's HDMI Cable going directly into my Onkyo 605 receiver has no video. I then installed the HDMI directly into my cable box instead, and ran the audio cable thru the Receiver and it works.

Are you sure in the Onkyo setup you have HDMI Monitor set to Yes. By default, I believe it is No, which would not send any video to your projector.

This is the second thread I've seen citing handshake problems with the Onkyo 605 and Panny AX200. I have the Onkyo, and the AX200 is on my short list of projectors.