When I ramp the left "edge all" focus up and down, there is no change on any of the edges until I get to -5%, then all of the sudden the right edge (yes the right edge) becomes twice as sharp. The other edges have minimal effect when I ramp up and down, and the corner focus does very little as well. The corner and edge focus is okay, but it definitly could be improved, which is why I went to the focus controls - too bad they didn't do anything :D. So Curt, where are ya.

Tweak the focus pots in the card cage. If you get what I call the 'sine wave effect', where you can move the in focus section from the center being blurry but the outside edges are great, then when the middle is clear the outside edges are fuzzy, then yes, the F board is bad.

Email me through my site, I can swap you rather than you wait for a repair if you want.

Change it to edge-seperate instead of edge-all.

Change it to edge-seperate instead of edge-all.

How? I press CTRL G, R, and B and it says key input error.

Go into the 'settings' menu, it's in there.

Go into the 'settings' menu, it's in there.

Oh.............Duh.....:o