hay guys, we have 2 moome internal hdmi cards installed in 2 different 9500lc's we are getting ringing (edging) on the moome cards, dosent matter on sources ( dvdo and ken's sencore generator ) swapped one of the cards out with the older dvi moome card and the ringing goes away, same cables etc. tried different polalritys h+ h+, h+ h-, h- h+, h- h-. all the same h+ h+ looks a tad better in some respects to the pic so that is what i left it.
both hdmi cards are doing it. the moome dvi is not. 2 other peoples cards are not either.
oh ya, 1080p 60hz.
mark haflich
11-26-07, 08:23 PM
SCREEN SHOT of the ringing please? Don't see any ringing with my new Moome in my 9500LC ultra.
Boomrat. You never gave us any feedback re our suggestions on your other ringing issue caused by improper selection of the retrace. :)
mark haflich
11-26-07, 08:24 PM
Hay Guys? Naw. Hey, I'd rather have a beer.
fixed the retrace issue, some banding left but alot less... i'll take some screen shots tomorrow.
thanks guys
mark haflich
11-27-07, 08:27 AM
Proper set up will eliminate the residual ringing. Do a random access converge on green reset, then go back to geometry and get the c lins exactly on, you will need straight vetical and horizontal center grid lines to set the c lins right on. Then s lins should cause no banding. Easy to introduce banding when you go back to random converge on green to obtain that perfect stacking grid. Start fom the center and work out checking for banding introduction at each click, a pain. Adjustments at the edges or one line in won't cause banding, but the next two zones in really do so be very careful and check and save often. Saving lets you go back to a pre banding position. I gather you are attempting a vertical Marquee stack for somebody. The adjustments in green grid that may be necessary to do this may cause banding. Adjustments to the horizontal lines in the zones around the center seem to cause banding.
Jim Kildare
11-27-07, 09:50 PM
fixed the retrace issue, some banding left but alot less... i'll take some screen shots tomorrow.
thanks guys
HOW???
Are you now using a processor or Htpc?
Did you use phase? 52-53 gets rid of a lot.
Cheers,
Jim