Does anyone know what I'm doing wrong?

I've programmed all the activities and programmed in the device settings with the proper lcd buttons for each device and command but when I start an activity the lcd screen buttons dont have the right commands that I programmed. However, when I go to the devices individually they have some of the right commands and not all of them. The software has everything set up properly, it just doesn't go to the remote when I update it.

Whats going on here?

You can have different LCD buttons for activities than devices. Make sure you are in the activities tab while changing your buttons (?)

My software has a devices tab and an activities tab for setting up. When I go to the devices tab it lets me change the lcd buttons but in the activities tab I can't find any way to change the lcd commands.

Also, in devices the lcd commands aren't the same as how I programmed them with the software.

I'm thinking it's updating to the remote wrong. Anyone have any suggestions?

I think I found what you're talking about. thanks