I have various audio components--need help building the best system with them

[andrewc2232]

So I'm a little bit of an audio noob, but I've managed to collect a few different components over the years. My problem is I'm not sure which I should be using to get the best 2 channel audio sound quality (this is what the system is used for 90% of the time).

I will be playing mostly vinyl, some CDs, and a lot of (high bitrate) MP3s off of my HTPC on this setup.

I have the following receivers:
Toshiba SA7150
Onkyo HT R500
Pioneer SX-424
Kenwood KC-207 (with Kenwood KM-207 amplifier)
Yamaha HTR 5890

The Toshiba would need to be repaired for me to use it, though I'm suspicious it would produce the highest quality sound of those listed. I have the repair manual and some knowledge of electronics--if it would drastically improve SQ I would be willing to take it apart and fix it.
The Kenwood stuff is part of that huge Spectrum 87B system they sold back in the late 80s. If it helps, I'm also using the speakers from this system (JL 975 AVs I think).

I have two turntables, one that came with the spectrum system, the Kenwood KD-87F, and an older Kenwood KD-2033. I have no idea if SQ varies between turntables or if either one of these is superior to the other.

So my question is: among this equipment, what would you guys use for the best 2 channel music quality? Does having a seperate amp (kenwood receiver/amp) make a noticeable difference, or would I be better off using the newer, nicer Yamaha? Is the Yamaha's built in amp better than the Kenwood KM-207?

And will the same setup produce be best for both a vinyl source and an analog (or digital?) signal coming from a PC? Or would one receiver be better for the vinyl while another (the Onkyo and Yamaha both have optical) would be better for MP3s?

Thanks for reading and thanks in advance for any suggestions or comments

Andrew

[mcnarus]

Assuming these are all in good working order (the Toshiba excepted), the sound quality will be very similar. I'd go with whichever offers the most power. Separates are not inherently better than receivers.

Can't help you on the turntables. Look them up on www.vinylengine.com. Remember that you need an input specifically labeled "phono" in order to connect a turntable directly, so be sure whichever receiver you have offers that.

The most important issue for any amp is power, and it doesn't matter whether the source is analog or digital. The phono stages in each could differ somewhat, but absent any better information I would assume all are comparable.

[Prehjan]

old kenwood amps are very well built..the one you have is a 120watt version...if i recall correctly!

I have six...count them six ka99 integrated amps from the fist months of the 90s and one of them has been on 24/7 since then...no problems what so ever.

Martin