In calibration my JVC 4810, I am using the following workflow and I want to see if I am doing gamma in the right order:
1) check meter position for max light output
2) brightness contrast
3) greyscale using offset and gain controls
4) gamma using multipoint controls (white only)
5) re-check greyscale
7) re-check brightness and contrast
I had very good results with a 2.3 gamma response and I dropped it to 2.2 at 20 and below. All greyscale errors are 1 or less. CMS is pretty good too, but needs further tweaking.
Am I doing gamma in the appropriate order?
Last edited by curlyjive; 06-16-2014 at 08:09 AM.