The current iNuke setup is as follows
Based on what I've read on the Data-Bass website along with these WinISD sims I was really hoping and looking forward to getting some decent 10-25Hz performance from the box.
I cant understand why the Sub15 is outperforming the dual 18.
With no EQ I have to run the dial just past 55% before the first clip light comes on
With EQ I have to run the dial about 25%. During 'Pod Emerge' on WOTW at reference I got all the iNuke lights to come on and there was significant pressure in the room.
I tried to use REW but could not get the sound card 100% and only using the Radioshack 33-2055-4050 unit and cal file.
Trying to keep the playing field at level as possible I captured these. I ran the output of my laptop directly onto the Sub15/iNuke input (bypassed Receiver and AS-EQ1)
IGNORE THE SPL - I was tried to gauge the response of one vs the other.
Average of 4 measurements. Each measurement is a 4x 5-300Hz 512k Sweeps
DO 18 NO EQ
DO 18 WITH iNuke EQ
The DO 18 response is just really poor below 40 and above 80 without EQ. The Sub15 has not have PBK done and was on bypass for all testing.
The room is the same for both units so not sure why the one is behaving so poorly compared to the other.
Bascially looking for some insight into what might be wrong. I've checked and no air-leaks. I moved the speaker down the wall towards the back of the room and measurements were worse.
Thinking of removing all damping and stuffing to see if it makes a difference. I'm not worried about <10Hz as my goal was more about >10Hz.
This is my first attempt at DIY and somewhat dishearten that things have not quite worked out especially seeing how many people are really happy with the Dayton HO 18 at the moment.
Help / Comments / Suggestions most welcome.