When I power the pj up the picture is nice and stable but after a while the picture starts rolling (after 5-10 minutes).
I´ve tried to change sync and to enable "source lock" but it doesn´t help.
Sorry I didn´t get back to you last time I wrote.
But the PJ has been working fine most of the time lately but now the problem has come back!
Menues are stable, same signalpath as before but I´ve now tried the set top box directly into the moomecard
, but the rolling continues. So either it is the moomecard or a card in the pj. I suspect in the projector.
Just now I got an error message "H-frequency limit over, power will be shut down", but it never did. I feed the
xg with 1080i 50 and 60Hz, and that should be no problem for the xg??
Those resolutions and refresh rates are no problem for the XG, it sounds like it is losing SYNC perhaps.
I'd pop the Moome Card and try connecting to the Projector via an RGB source and see if the problem continues. Do you have a HDFury or similar?
....well this time the problem was easily solved just by moving the moomecard from slot c to slot b!
.. and yes it is a syncproblem and maybe a problem with the contacts! neonsky, how did you clean the contacts?
Did you clean both the hdmi input contacts and the contacts conecting the moomecard with the projector?
I´ve found a cleaningspray for electrical contacts. Maybe good to use for cleaning these contacts?
That solution should be fine. All I did was spray it on the contacts where it connects to the projector (internally), did a quick inspection, plug it back in, and done. My issue was prolly just a handshake issue but never hurts to clean stuff once in awhile. No reason to clean the actual HDMI connectors.