I'm currently running my 1031 on a samsung ts-360, and a pc sometimes. I have the samsung set for 4:3 and 480i/p and it works fine directly out of the vga to the projector, it letter boxes the HD stuff and does full screen for ps2 and such. If I switch it to 1080i no picture shows up, so I ran it thru a sync convertor and it shows up. When i go to 16:9 and 1080i for the settings on the box, the picture is bigger than the projector puts out, like watching a 4:3 section of a 16:9 picture. I did notice the picture is much brighter than the output of the 480i/p setting. Do I need a scaler or do I need to squeez the picture using the settings on the projector? I have a HD tuner card in the pc, if I set powerstrip to 1080i what will I need to do to get the correct 16:9 image? What I'm trying to do is get 1080i in a 16:9 format with the componants I already have. Any input would be appreciated. Thanks. I haven't seen to much on this subject and the badboyz site doesn't really go in to much with the set-up i have. Also, the Extron sync convertor I have had a vga input but a RGBV out put, so i need to run a few cables to convert it to the big sony connector, is there a sync convertor out the with std vga input and outputs?