using stepper to break away audio - AVS Forum
Forum Jump: 
 
Thread Tools
post #1 of 1 Old 02-11-2013, 09:01 PM - Thread Starter
Newbie
 
androidnacho's Avatar
 
Join Date: Feb 2013
Posts: 1
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Liked: 10
Hello. I am starting to program more in SIMPL and I did a project using System Builder not too long ago. The client wants to add more features, one of them being able to choose a source and send it to one or both displays.

the setup is as follows:

MPC-M25.

HD-MD8x2 (Cresnet)

8 sources, all HDMI.

2 Sharp LC-70LE rs232

So, the idea is to select a source (assigned to buttons 2-9) and then select a destination (left or right TV, or both)

The logic to apply here is that the last source selected will carry both audio n video. Because the HD-MD8x2 can do breakaway audio, I need mute it so when a source is send to one TV, the other output's audio is disable (muted).

Which symbol(s) can I use to accomplished this? Steppe sounds like a good candidate, but I would like your input or ideas.

Also, there is a delay between the left and right audio signal, due to latency inside the HD-MD8x2

Thanks..
androidnacho is offline  
Reply Home Automation

User Tag List

Thread Tools
Show Printable Version Show Printable Version
Email this Page Email this Page


Forum Jump: 

Posting Rules  
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off