Remote Codes in Binary Form? - AVS Forum
Forum Jump: 
 
Thread Tools
post #1 of 2 Old 04-20-2001, 12:49 PM - Thread Starter
AVS Special Member
 
Glimmie's Avatar
 
Join Date: Sep 2000
Location: Los Angeles, CA
Posts: 7,947
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 146 Post(s)
Liked: 215
Is there a site where the hex codes for manufactures remotes are listed along with any special timing requirments?

My HTPC is the control center and many of my devices were either equipped or modified for RS232 control. But my Poineer RPTV needs to switch the video inputs depending on the source, composite, SVideo, RGB. I would like to simply send the command out a parallel port pin and drive an IR LED.

Barring that I will buy a cheap programmable remote and tack FET's (solid state switches) across the PC board switches. A kludge for sure but it will work.

Glimmie's HT Page
Being redone - comming soon!

Glimmie is offline  
Sponsored Links
Advertisement
 
post #2 of 2 Old 04-20-2001, 03:49 PM
Advanced Member
 
Ricardo Cruz's Avatar
 
Join Date: Nov 1999
Location: Lisboa, Portugal
Posts: 704
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Liked: 10
You can try:

www.remotecentral.com
www.prontoedit.com

to get the codes programmed in the Prontos. Then download a file from these locations (sorry, don't remember it's name) to get the Hex, or you can use Pronto Emulator (even if you don't own the Pronto) to read this Hex. The forums at both of these sites will make this clearer than I can.

Regards, RC

Regards, RC
Ricardo Cruz is offline  
Closed Thread Home Theater Computers

User Tag List

Thread Tools
Show Printable Version Show Printable Version
Email this Page Email this Page


Forum Jump: 

Posting Rules  
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off