Just Multiroom Audio distribution - Page 2 - AVS Forum
Forum Jump: 
Reply
 
Thread Tools
post #31 of 33 Old 12-06-2011, 10:21 AM
AVS Special Member
 
jautor's Avatar
 
Join Date: Jun 2001
Location: Houston, TX
Posts: 7,768
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 109 Post(s)
Liked: 349
Quote:
Originally Posted by ravi355 View Post

I installed the Xantech Digi5 last week and not sure why the sound quality is not that good . I mean , I tested the speakers when installed by playing songs from a CD changer and hooking them directly to the Speakers and the sound was good . But once I attach the wall controllers and Xantech 4 zone controller , the same songs sound so Bad . I mean there is no good base in the sound .

I even fiddled with the setup settings and still cannot figure it out . Could it be due to the fact that the cat5 is about 100ft ?

Please don't repost the same question bumping old threads...

Not likely a wiring issue, since the amplification is happening at the local end anyway.

When you say you tested the speakers - with which equipment? Did you hook them sitting on the floor to an A/V receiver? Are these in-wall/ceiling speakers? They'll certainly sound different when installed...

Too many variables - you have to change only one thing at a time.

Jeff

Rock Creek Theater -- CIH, Panamorph, Martin Logan, SVS PB2000, Carada Masquerade, Grafik Eye, Bar table, Green Glue, JVC RS50 
Theater build photos: http://photobucket.com/autor-ht

jautor is offline  
Sponsored Links
Advertisement
 
post #32 of 33 Old 12-07-2011, 12:03 PM - Thread Starter
Member
 
ravi355's Avatar
 
Join Date: May 2004
Posts: 58
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Liked: 10
I tested them once the speakers were installed in the ceiling after running the wires and connected to a CD changer with built in Amp . I am not worried about the amount of sound as the xantech only does 30w per channel , but the actual quality of the sound is different if I hook up the same CD changer to the source1 on the xantech ...
ravi355 is offline  
post #33 of 33 Old 07-16-2012, 01:12 PM
Member
 
shaurya's Avatar
 
Join Date: Jun 2005
Posts: 19
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Liked: 10
Hi Ravi,
Hope you are enjoying your system. I have been thinking about the same and have few questions?
How has been your experience with Xantech DIGI-5 so far?
Any issues?
Do you have the wall mount or rack mount?
Would you recommend it?
How is the overall quality of the system/keypad etc. (Build quality & audio)?
Have you encountered any bugs or severe technical issues? Any issue with IR or the Serial RS-232 port?

Hi Jautor/Eric
I see that you have have posted fairly about this DIGI-5 system. Any experience as user or installer or troubleshooter? Any know issue around build/sound quality or known system bugs/issues?

Would love to give you a call to all of you if you are OK.
Regards, Shaurya
shaurya is offline  
Reply Home A/V Distribution

User Tag List

Thread Tools
Show Printable Version Show Printable Version
Email this Page Email this Page


Forum Jump: 

Posting Rules  
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off