Another volume control setting question - mixed speaker impedance - AVS Forum
Forum Jump: 
 
Thread Tools
Old 12-04-2012, 05:21 PM - Thread Starter
Newbie
 
efenska's Avatar
 
Join Date: Nov 2012
Posts: 3
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Liked: 10
Read several posts here but I'm still not too clear on the jumper settings for the impedance-matching volume controls for 2 pairs of speakers connected to an amp via a speaker selector switch. The setup is:

-Yamaha AW390 speakers rated at 6 ohms connected to a Monoprice impedance-matching VC.
-Monoprice 8" in-ceiling speakers connected to a Monoprice impedance-matching VC.
-Speaker selector switch (no impedance-matching).
-2 channel amp rated at 8 ohms.

Near as I can tell from other posts, I should probably treat the 6-ohm speakers as 4-ohm for the sake of setting the jumpers since the Monoprice VC's don't list 6-ohm jumper settings.

Do I set the jumpers for both VC's according to the total pairs of speakers I have connecting back to the amp? If I do that then I would set both VC's to x4, as if I had 3 sets of 4-ohm speakers. Do I have this right or am I missing something?

Thanks for the help...
efenska is offline  
 
Thread Tools


Forum Jump: 

Posting Rules  
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off