Bottom of image cropped off? - AVS Forum
Forum Jump: 
 
Thread Tools
post #1 of 1 Old 12-05-2013, 01:00 PM - Thread Starter
Advanced Member
 
speters's Avatar
 
Join Date: Oct 2001
Location: SF,CA
Posts: 973
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Liked: 10
I have the Iscan Duo, which I have been using since it first came out, and I had the VP before this. I have it connected to the JVC RS-45 projector. I recently sent the projector in for repair. I set the projector back up, used the geometry test pattern from the Iscan, and adjusted image size and position using the JVC, and everything was fine. A few days later I noticed that the the image looked like it had gotten moved down about an inch. So I went into the geometry test pattern of the Iscan again, and noticed that the bottom of the test pattern was cut off. I adjusted the image up using the JVC, and the bottom of the test pattern was still cut off. So I went into the Iscan and checked the border level and mask level, and they where both at 0. I also noticed that if I adjust the screen position, again with the JVC settings, so that the top of the geometry frame is at the very edge of my screen I still see about an inch of the screen when viewing an actual image. Then if I check the screen position pattern of the JVC it is actually about an inch below where the top edge of the geometry test pattern is. In the past I have not had this issue and I am not sure what is going on? Any thoughts?

Thanks,
Steve
speters is offline  
Reply Video Processors

Tags
Jvc Dla Rs45 Home Theater Projector 1080p Hdmi
Gear in this thread - 1080p by PriceGrabber.com

Thread Tools
Show Printable Version Show Printable Version
Email this Page Email this Page


Forum Jump: 

Posting Rules  
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off