D-Board removal on PT-53WX53 to r&r conv. IC's
In preparing to replace the STK 392-110 IC's (convergence chips) I've been reading all I can and ran across a couple of people stating that the D board cannot be fully removed from the TV and must have the chips replaced while the board is still connected by 1 wire. I've only seen this statement a couple of times and I know better than to not at least check it out.
Anyone have any knowledge or ideas about this?
I was given this used PT-53WX?? RPTV with the model#, chassis# sticker missing, so I'm not 100%% sure what exact model it is except that it is a 53WX. I have rounded up a service manual and user manual that covers a range of models but no documentation on replacing the conv. IC's.
Any insight will be GREATLY appreciated.
"if you don't play well with others,
you could end up playing with yourself"
Last edited by mchldpy; 07-29-2014 at 08:47 PM.
Reason: change removel to removal