AVS Forum Special Member
Join Date: Sep 2000
Location: Northern California
Mentioned: 1 Post(s)
Tagged: 0 Thread(s)
Quoted: 169 Post(s)
Quick guide to removal/install of crt:
Tighten the lens adj nut.
Remove crt board, svm board/windings, yoke/windings, ground wires (suggest labelling/marking posistions so you don't end up with an upside-down picture), and HV anode from Flyback/Tripler.
Unscrew from mount, lift out.
Detach lense assembly from tube.
Split, Clean, Refill, Seal.
Now put crt back in, assemble in reverse, apply power and hope for the best.
You will have to do mech convergence, digital convergence, hardware grayscale, and maybe SM grayscale.
If you are doing more than one, do them one at a time (get mech convergence close on the new crt before removing the next one).
XBR-65Z9D | AVR-X2200W | UBD-K8500 | JRMC HTPC w/9 cable tuners | Fluance SV 7.1 + eD A3-300