I know the Infocus X-10 is pretty old by today's standards, but that's what I'm using. I was wondering if anybody that owned one had ever run into this situation where the projector bulb would be fine, bright in fact, with only 486 hours on it and suddenly the unit shuts down and locks up where I can't restart it? Unplugging the unit and replugging it in allows me to restart the projector but again, after less than 2 minutes it shuts down. I installed the original old bulb and it works fine, just a dim picture. I installed a lousy, fake bulb (just like the original they said) and it works but it's a terrible picture.
I took the bulb out, cleaned the mesh screen and tried again and it still shuts down after a minute or two. The image would take a while to get nice and bright then suddenly when it's at full strength the projector shuts down. I tried changing the bulb housing to the old OEM unit but that didn't do anything, of course. It's irritating that after less than a year (it's only a few days before it's a year old) the bulb doesn't allow the projector to work properly. Any ideas?