HD20 no power after wheel and sensor replacement - AVS Forum
Forum Jump: 
 
Thread Tools
post #1 of 2 Old 01-29-2013, 01:49 PM - Thread Starter
Newbie
 
notqytryt's Avatar
 
Join Date: Jun 2009
Posts: 3
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Liked: 10
I had a problem with the color wheel so I replaced it, also had to replace the sensor for the color wheel.... (everything was working before) now after being reassembled it will not power up,,, It has a steady green flashing light,
(there were only 3 cables removed during the whole procedure... Anyone have a clue why it wont power up.. Ive eliminaed the possibility of the lamp door switch being the problem.... eek.gif
notqytryt is offline  
Sponsored Links
Advertisement
 
post #2 of 2 Old 01-29-2013, 03:56 PM
AVS Special Member
 
Sheridan1952's Avatar
 
Join Date: Aug 2002
Location: Texas
Posts: 1,918
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Liked: 16
Since it worked before you started, it HAS to be something you didn't get back right. You're going to have go back in and double-check everything. I'm guessing you didn't get the ribbon cables back in properly. Did you just PULL them out or did you actually release the keepers, allowing them to just fall out?
Sheridan1952 is offline  
Reply Digital Projectors - Under $3,000 USD MSRP

User Tag List

Thread Tools
Show Printable Version Show Printable Version
Email this Page Email this Page


Forum Jump: 

Posting Rules  
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off