Panasonic Aspect Detect changes image position - AVS Forum
Forum Jump: 
 
Thread Tools
post #1 of 1 Old 02-02-2013, 03:47 PM - Thread Starter
Member
 
RTPBob's Avatar
 
Join Date: May 2002
Location: Cary, NC
Posts: 129
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Liked: 10
Just getting ready to build a new DIY screen that is a 2.40:1. Prior to the build, I've been experimenting with the aspect detect and lens memory settings in an attempt to finalize my dimensions. My problem is if I set-up the projector for a centered 16:9 picture, when the projector detects a 2.40:1 input and starts processing the image jumps vertically upward about one foot. The only way I can re-position the image is with the manual vertical positioning knob on the top of the projector. The electronic image positioning function does not allow for enough movement to recenter the picture.

As most blu-ray disks start with 16:9 and then switch to 2.40:1 then back to 16:9 for the menus....I'm having concerns about how practical these features are. I am projecting from the front off of a table with is about level with the bottom of the screen.

Anyone familiar with this problem and know a solution?

Thanks for any ideas
RTPBob is offline  
Reply Digital Projectors - Under $3,000 USD MSRP

Thread Tools
Show Printable Version Show Printable Version
Email this Page Email this Page


Forum Jump: 

Posting Rules  
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off