Bi-wiring/Bi-amping Jamo S606 - AVS Forum

AVS Forum > Audio > Speakers > Bi-wiring/Bi-amping Jamo S606

Speakers

KidRobot's Avatar KidRobot
10:09 AM Liked: 10
post #1 of 2
01-08-2013 | Posts: 1
Joined: Jan 2013
Trying to wrap my head around this new setup I got over the holiday season.

Previous to this, I was running an old Yamaha RX-V457 with a Bose Acoustimass 6 Series II system.

Finally took the plunge to upgrade and picked up a Denon AVR-1713, a Jamo S606HCS3, and waiting for delivery of the Klipsch RW-12D subwoofer to complete the system.

Question is, is there a way I can bi-wire the Jamo S606 floor speakers, so I can use the 8" woofers properly?

My main concern is, the Audyssey setup will be treating the tower speakers as full range, and I'm wondering if I can somehow use the Zone 2 outputs from my AVR-1713 to, perhaps, a separate sub amp?

Is this setup feasible? Or am I just making a bigger deal than needed for these 8" woofers in the towers?
Bill Fitzmaurice's Avatar Bill Fitzmaurice
10:19 AM Liked: 1770
post #2 of 2
01-08-2013 | Posts: 10,507
Joined: Nov 2009
Bi-wiring doesn't do anything. Bi-amping does, but it's only marginally effective if the passive crossovers inside the speaker aren't bypassed. If you want to try bi-amping your speaker and receiver manuals should tell you how to do it.
Reply Speakers

Subscribe to this Thread

Powered by vBadvanced CMPS v3.2.3