Help with Jamo mpa-101 - AVS Forum | Home Theater Discussions And Reviews
Forum Jump: 
Thread Tools
post #1 of 1 Old 02-01-2013, 06:07 AM - Thread Starter
dbaughn's Avatar
Join Date: Jan 2013
Posts: 2
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Liked: 10
I have just installed the following system and believe i may have burned up my amp. If any one has any thoughts on where i went wrong please advise. I have 6 zones of 8 ohm sononce speakers for a total of 12 speaker in my house. each zone is wired with a four conducter wire from my media closet to a impemdence matching volume control in each of the 6 zones and from the 6 diffrent volume controls to each set of speaker in that zone. i wired all of the speaker home runs (4 conducter wire) together in the media closet and pigtailed off of that in to a Jamo mpa-101 amplifier that is connected to a sonos connect as the only source. all of the wires are in parrallel so +6 reds _6 blacks on right side and left side +6 whites and -6 greens then went into the amp. the amp shows to be 2x50 watt 4ohm and 2X100 watt 8ohm. i went with this amp because of lower cost and fiugred i would not be running more than 2 or 3 zones at any given time.
Thanks for any assistance you may provide.
I posted this in the 2 channel forum but no repsonse maybe someone here has some insight.
dbaughn is offline  
Sponsored Links
Reply Receivers, Amps, and Processors

Thread Tools
Show Printable Version Show Printable Version
Email this Page Email this Page

Forum Jump: 

Posting Rules  
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off