Help in this problem is realy needed as right now i have no reciver at all and getting any help from onkyo is like getting blood out of a stone also the reciver is out of warranty so getting it repaired will cost me more than the unit is worth
User Nilsvoss (on the forum) posted a fix over here:
Might be some talk of it here, but I think all of it's over there:
Oh wait, you posted over there.
To answer your question, you can up the wattage (if there is room) but not the ohms usually. But like Nils did there, I have made substitutions that were close (but not exact) and it worked. This is more of an advanced thing and when you are starting out, I would stick to the exact parts if I was you.
You can't really shotgun this problem. You will have to see where the voltages are getting to. Also, (especially if all the voltages look good) check for cold solder joints where the display tub itself solders into the board.
Living Room Home-Theater:
Epson 8350 1080p Projector (96") / Panasonic TH-46pz850u 46" 1080p Plasma TV
Onkyo TX-sr607 AVR-Amplifier (7.2ch ~ HDMI ~ 630 watts)
AppleTV-4 / Panasonic DMP-BD60 Blu-Ray Disc Player / Cisco 8742hdc DVR (TWC)
Harmony 670 Remote / HTPC (Kodi/Win7-64) Media Server PC / Synology 12tb Raid-5 NAS
Polk Audio Monitor Series II Speakers (Large 6.1 Matched Separates) / PSW505 12-Inch Sub
|Onkyo Tx Sr607 Receiver|
|Gear in this thread|