AVS Forum - Search Results
Showing results 1 to 25 of 331
Search took 0.14 seconds.
Search: Posts Made By: BillCinLR
Forum: Subwoofers, Bass, and Transducers   08-07-2013, 12:08 PM
Replies: 20,450
Views: 2,115,528
Posted By BillCinLR
No, the 18 inch subs used a different amp than...

No, the 18 inch subs used a different amp than the legends.

Bill C
Forum: Subwoofers, Bass, and Transducers   04-03-2013, 02:05 PM
Replies: 5
Views: 335
Posted By BillCinLR
The DTS-10 (Also known as the "SPUD") is...

The DTS-10 (Also known as the "SPUD") is manufactured and sold by Tom Danley:

http://www.danleysoundlabs.com/products/subwoofers/tapped-horns/th-spud/

The DTS-10 KITS were sold at half of the...
Forum: Subwoofers, Bass, and Transducers   04-03-2013, 01:49 PM
Replies: 1
Views: 190
Posted By BillCinLR
You need to CAREFULLY pry the amplifier away...

You need to CAREFULLY pry the amplifier away from the enclosure using a putty knife or screwdriver. It isn't glued, but getting the gasket material to turn loose will take a lot of effort. You only...
Forum: Subwoofers, Bass, and Transducers   03-18-2013, 10:48 AM
Replies: 4
Views: 256
Posted By BillCinLR
If the reason for replacing the speaker is a...

If the reason for replacing the speaker is a rotted surround ... re-foaming kits are quite inexpensive and readily available.

Just a thought,

Bill C
Forum: Subwoofers, Bass, and Transducers   03-13-2013, 08:14 AM
Replies: 18
Views: 459
Posted By BillCinLR
When running Audyssey calibration, it will have...

When running Audyssey calibration, it will have you set the subwoofer output to 75db as measured by the ONKYO mike that comes with the AVR.

Bill C
Forum: Subwoofers, Bass, and Transducers   03-06-2013, 09:27 AM
Replies: 4
Views: 887
Posted By BillCinLR
Yes, the "OUT" position is correct. Bill...

Yes, the "OUT" position is correct.

Bill C
Forum: Subwoofers, Bass, and Transducers   03-06-2013, 09:23 AM
Replies: 4
Views: 887
Posted By BillCinLR
Set the switch so the receiver sets the...

Set the switch so the receiver sets the crossovers, then run the Audyssey automatic setup

Bill C
Forum: Subwoofers, Bass, and Transducers   03-06-2013, 09:19 AM
Replies: 4
Views: 4,126
Posted By BillCinLR
Yes, that is correct. Bill C

Yes, that is correct.

Bill C
Forum: Subwoofers, Bass, and Transducers   03-06-2013, 08:01 AM
Replies: 4
Views: 4,126
Posted By BillCinLR
Connect a RCA Subwoofer cable like this: ...

Connect a RCA Subwoofer cable like this:

http://www.monoprice.com/products/product.asp?c_id=102&cp_id=10236&cs_id=1023603&p_id=2682&seq=1&format=2

from your "Subwoofer OUT" on the receiver to...
Forum: Subwoofers, Bass, and Transducers   02-28-2013, 04:47 AM
Replies: 10
Views: 3,651
Posted By BillCinLR
You don't usually use both high and low level...

You don't usually use both high and low level inputs at the same time ... its one or the other (Speakers In/Out or just an RCA cable).
If you get no results using just ONE of the methods at a time,...
Forum: Subwoofers, Bass, and Transducers   02-27-2013, 02:40 PM
Replies: 10
Views: 3,651
Posted By BillCinLR
Make SURE that you are using "Subwoofer OUT" on...

Make SURE that you are using "Subwoofer OUT" on the receiver and not an input.

Not sure why you are running front speakers out of the subwoofer.

If your connections are all correct, then you...
Forum: Subwoofers, Bass, and Transducers   02-27-2013, 02:11 PM
Replies: 10
Views: 3,651
Posted By BillCinLR
Go into "Menu/Setup" Select "Manual...

Go into "Menu/Setup"
Select "Manual Setup/Speaker Setup"
Set "Subwoofer" to "Yes"

Bill C
Forum: Subwoofers, Bass, and Transducers   12-18-2012, 01:12 PM
Replies: 20,450
Views: 2,115,528
Posted By BillCinLR
Do a search for "Chad Kuypers", the owner of...

Do a search for "Chad Kuypers", the owner of EPIK Subwoofers and you will see when he has posted here.


Bill C
Forum: Subwoofers, Bass, and Transducers   12-06-2012, 01:01 PM
Replies: 10
Views: 626
Posted By BillCinLR
10,000+ cu ft is BIG ... dual Legends and even...

10,000+ cu ft is BIG ... dual Legends and even dual EMPIRES may not provide what you are looking for in bass response. If you are set on the Legends, try placing them near the seating/listening...
Forum: Subwoofers, Bass, and Transducers   12-05-2012, 12:49 PM
Replies: 10
Views: 626
Posted By BillCinLR
If Audyssey is setting the level at -12, you are...

If Audyssey is setting the level at -12, you are running the sub too loud before calibration. When the sub level is correct, it should end up at -3 to +3 db.

Bill C
Forum: Subwoofers, Bass, and Transducers   11-18-2012, 06:54 AM
Replies: 6
Views: 899
Posted By BillCinLR
Since you are having the same problem with both...

Since you are having the same problem with both cables, go back, look at the instructions for mounting the cable ends, and be absolutely certain they are installed correctly.

Bill C
Forum: Subwoofers, Bass, and Transducers   11-13-2012, 07:51 AM
Replies: 3
Views: 230
Posted By BillCinLR
The problem may be as simple as a bad RCA cable...

The problem may be as simple as a bad RCA cable between the receiver and the sub ... try a new known-to-be good cable.

Bill C
Forum: Subwoofers, Bass, and Transducers   11-05-2012, 03:25 PM
Replies: 3
Views: 571
Posted By BillCinLR
NO! NOT a good idea. Spend $50 on a Sub-Duide to...

NO! NOT a good idea. Spend $50 on a Sub-Duide to DE-couple the subwoofer from the floor.

Good luck,

Bill C
Forum: Subwoofers, Bass, and Transducers   09-16-2012, 06:28 AM
Replies: 16
Views: 827
Posted By BillCinLR
This is WAAAAAAY too late, but when I thought...

This is WAAAAAAY too late, but when I thought one of my EPIK 18" subwoofers had a bad amp, I was considering powering it with a Crown Pro amp. It turned out that the amp wasn't bad after all, but...
Forum: DIY Speakers and Subs   08-09-2012, 09:03 AM
Replies: 8
Views: 286
Posted By BillCinLR
See if this might help: ...

See if this might help:

http://www.diysoundgroup.com/subwoofer-flatpacks.html

Bill C
Forum: Subwoofers, Bass, and Transducers   08-08-2012, 11:23 AM
Replies: 20
Views: 443
Posted By BillCinLR
Electronic components fail ... that's just life....

Electronic components fail ... that's just life. Like a light bulb that came on the last time you threw the switch, but now it doesn't because it is burnt out. An uncontrollable amp is just as bad...
Forum: Subwoofers, Bass, and Transducers   08-08-2012, 05:23 AM
Replies: 20
Views: 443
Posted By BillCinLR
I think that you have already answered your own...

I think that you have already answered your own question ... BAD AMP!

Bill C
Forum: Subwoofers, Bass, and Transducers   08-07-2012, 12:12 PM
Replies: 10
Views: 412
Posted By BillCinLR
Lightning strikes are hardly a test of...

Lightning strikes are hardly a test of reliability! Lightning can take out ANY gear, regardless of cost, quality, etc. Are you using surge protection? If not ... it is a good idea to start.

Good...
Forum: Subwoofers, Bass, and Transducers   07-14-2012, 09:59 AM
Replies: 20,450
Views: 2,115,528
Posted By BillCinLR
I also have a 37 month old EPIK Dragon that...

I also have a 37 month old EPIK Dragon that suddenly stopped working. After checking the power cord and fuse, which turned out to be good, I thought that the amp was dead. After some thought, I...
Forum: Subwoofers, Bass, and Transducers   07-09-2012, 07:51 AM
Replies: 18
Views: 1,470
Posted By BillCinLR
Mike, A bad amp is the usual cause for...

Mike,

A bad amp is the usual cause for blown fuses and the Legend is known to have amp failures ... WHEN you get in touch with Chad, he will no doubt get you going again.

Good Luck,

Bill C
Showing results 1 to 25 of 331

 
Forum Jump: