AVS Forum - Search Results
Showing results 1 to 13 of 13
Search took 0.01 seconds.
Search: Posts Made By: majkman
Forum: Receivers, Amps, and Processors   10-11-2014, 10:28 AM
Replies: 6,159
Views: 652,294
Posted By majkman
You will also note a green dot on the Serial...

You will also note a green dot on the Serial Number Sticker in the back. The network MAC address will have changed. Each of my 809's made the trip in 2 weeks from the time FedEx picked up to FedEx...
Forum: Receivers, Amps, and Processors   10-03-2014, 10:40 PM
Replies: 6,159
Views: 652,294
Posted By majkman
Thats neet- Thanks

Where does it SAVE the settings? on the USB stick? Will it survive servicing with boards and Firmware being replaced? WHO KNEW -KEWL?


Thank you.
Forum: Receivers, Amps, and Processors   10-01-2014, 08:13 PM
Replies: 6,159
Views: 652,294
Posted By majkman
Sent the first TX-NR809 back, quick turnaround too

Good news:
First TX-NR809 off and back within 2 weeks, installed it on Sunday. Guess they really did change the network card because it now has a different MAC address- needed to make some router...
Forum: Receivers, Amps, and Processors   01-24-2013, 12:28 PM
Replies: 6,159
Views: 652,294
Posted By majkman
Being LAZY, I would use a long (say 100...

Being LAZY,

I would use a long (say 100 Foot cable, if necessary), instead of draging the reciever.
Forum: Receivers, Amps, and Processors   08-04-2012, 04:40 PM
Replies: 6,159
Views: 652,294
Posted By majkman
I keep a 300 foot Ethernet cable around for...

I keep a 300 foot Ethernet cable around for special events, like moving into a new place, or to prove that the house wiring is not the problem to the cable company. I also keep a 300 foot RJ11...
Forum: Receivers, Amps, and Processors   08-04-2012, 01:15 PM
Replies: 6,159
Views: 652,294
Posted By majkman
IF you are unsure of your network connedtion,...

IF you are unsure of your network connedtion, break down and either run a cable over the floor for an hour, or use the USB option. http://files.avsforum.com/images/smilies/eek.gif
Forum: Receivers, Amps, and Processors   12-28-2011, 03:43 PM
Replies: 6,159
Views: 652,294
Posted By majkman
Did not see the settings tab, but now I do!...

Did not see the settings tab, but now I do! Thanks.
Forum: Receivers, Amps, and Processors   12-28-2011, 01:00 PM
Replies: 6,159
Views: 652,294
Posted By majkman
I installed OyRemote on 64 Bit windows 7, I...

I installed OyRemote on 64 Bit windows 7, I edited the XML file to point to my reciever, it (from what i remember) defaults to 192.168.0.1 or something like it. You also need to let the firewall...
Forum: Receivers, Amps, and Processors   12-16-2011, 12:42 PM
Replies: 6,159
Views: 652,294
Posted By majkman
Thank you for your thoughts, I was trying to get...

Thank you for your thoughts, I was trying to get both 809's to the same level, trying the net update first (a few times), then USB.Initially I could see the 2nd units' webservice page, but not the...
Forum: Receivers, Amps, and Processors   12-16-2011, 10:06 AM
Replies: 6,159
Views: 652,294
Posted By majkman
I liked the TX-NR809 so much that I purchased a...

I liked the TX-NR809 so much that I purchased a second unit for another room. Having set up both 809's there were some differences. The first unit was purchased in July, and the second was purchased...
Forum: Receivers, Amps, and Processors   05-26-2011, 09:53 PM
Replies: 1,837
Views: 279,864
Posted By majkman
Can you use a UPS to keep power to the amp while...

Can you use a UPS to keep power to the amp while driving it to the service center? (Power to the amp, but the amp not powered up)
Forum: LCD Flat Panel Displays   11-12-2009, 09:13 AM
Replies: 2,033
Views: 301,918
Posted By majkman
I thought the issues were: 1- When running...

I thought the issues were:
1- When running only HDMI thru a non SHARP receiver, message "An Incompatible Audio Signal Has Been Received, etc., etc.". Workaround is to leave the volume turned down...
Forum: LCD Flat Panel Displays   11-11-2009, 03:03 PM
Replies: 2,033
Views: 301,918
Posted By majkman
I've ordered my LC-65E77UM, should be here early...

I've ordered my LC-65E77UM, should be here early next week. Since I just upgraded the firmware on my 46" Sharp LCD's, I decided to look, and yes there is an upgraded Firmware for the new tv. Has...
Showing results 1 to 13 of 13

 
Forum Jump: