AVS Forum - Search Results
Showing results 1 to 25 of 5000
Search took 9.17 seconds.
Search: Posts Made By: batpig
Forum: Speakers   12-19-2014, 08:50 PM
Replies: 52,802
Views: 3,906,122
Posted By batpig
This is the same problem when they were shipped...

This is the same problem when they were shipped from Vanns a few years ago. The RC-10's and RC LCR are packed very well with two pieces of thick foam covering the speakers and no damage likely to...
Forum: Speakers   12-19-2014, 08:48 PM
Replies: 52,802
Views: 3,906,122
Posted By batpig
Not to nitpick but it's the C-R3 not the R1 that...

Not to nitpick but it's the C-R3 not the R1 that is the precursor to the RC-R. The R1 is a basic 2-way bipolar with a single woofer and dual opposing tweeters. More like the recent CR-10 (although...
Forum: Receivers, Amps, and Processors   12-19-2014, 08:40 PM
Replies: 4,417
Views: 201,277
Posted By batpig
I wont blow the speakers? 6ohm on the X5200 is...

I wont blow the speakers? 6ohm on the X5200 is 175watt i believe.[/QUOTE]
If you put tires rated to 130mph on a car that can go 175mph do the tires blow up when you are cruising on the highway at...
Forum: Speakers   12-19-2014, 06:59 AM
Replies: 52,802
Views: 3,906,122
Posted By batpig
I just can't believe Frys would rather send...

I just can't believe Frys would rather send speaker after speaker and end up with damaged returned inventory than simply correct the problem. Unbelievable.
Forum: Receivers, Amps, and Processors   12-19-2014, 06:43 AM
Replies: 4,417
Views: 201,277
Posted By batpig
Spotify Connect has always worked perfectly for...

Spotify Connect has always worked perfectly for me. In fact I find it a bit slicker and more robust overall than AirPlay. My receiver is hard wired.
Forum: Receivers, Amps, and Processors   12-19-2014, 06:40 AM
Replies: 4,417
Views: 201,277
Posted By batpig
I actually agree with this too. It would be...

I actually agree with this too. It would be easier if everyone just had .1 listed since that's more traditional nomenclature convention. And sub count is not really the point of the spreadsheet.
Forum: Receivers, Amps, and Processors   12-17-2014, 07:34 AM
Replies: 10,790
Views: 669,746
Posted By batpig
Personally, unless you had zero interest in...

Personally, unless you had zero interest in Atmos, I would get the newer model. Normally I'm an advocate of getting the higher end but slightly older model as better bang for the buck, but Atmos is...
Forum: Receivers, Amps, and Processors   12-17-2014, 06:50 AM
Replies: 9,864
Views: 743,978
Posted By batpig
It's definitely a real thing. Too many people...

It's definitely a real thing. Too many people have reported it, and it was happening to me too. My X4000 would randomly shut itself off with no apparent cause. I went so far as to literally leave the...
Forum: Speakers   12-17-2014, 06:44 AM
Replies: 52,802
Views: 3,906,122
Posted By batpig
Holy moly. $75 each with free shipping. Quite the...

Holy moly. $75 each with free shipping. Quite the score. I don't watch eBay that tightly but it seems like it's only the crummy EAS versions all the time.
Forum: Speakers   12-16-2014, 09:08 PM
Replies: 52,802
Views: 3,906,122
Posted By batpig
If you think $700 is bad he was originally trying...

If you think $700 is bad he was originally trying to get $1200. Got so much flak in this thread that he said FU and stopped posting here.

I understand the desire to hang onto them. I have a pair...
Forum: Speakers   12-16-2014, 08:27 PM
Replies: 52,802
Views: 3,906,122
Posted By batpig
If you want to sell those RC-Rs they will go in a...

If you want to sell those RC-Rs they will go in a flash. Very hot commodity since they aren't being produced anymore, but lots of people snagging 70s and 10s at Frys.
Forum: Receivers, Amps, and Processors   12-16-2014, 08:23 PM
Replies: 4,417
Views: 201,277
Posted By batpig
With the current generation Denon / Marantz...

With the current generation Denon / Marantz processors, you can't do a full 13.1 Auro setup since they are limited to 11ch processing. So Auro maxes out at 10.1 (5.1 + 4 heights + overhead VOG).
...
Forum: Subwoofers, Bass, and Transducers   12-16-2014, 04:32 PM
Replies: 3,059
Views: 141,680
Posted By batpig
The Bose module is NOT a real subwoofer. You...

The Bose module is NOT a real subwoofer. You would be much better served not splitting the signal, and instead simply letting the Bose bass module handle the upper/mid bass for the cubes and then...
Forum: Receivers, Amps, and Processors   12-14-2014, 12:21 AM
Replies: 9,864
Views: 743,978
Posted By batpig
If you have 4 ceiling speakers you really should...

If you have 4 ceiling speakers you really should go Atmos. It may hurt the wallet short term but I would return the 4000 and swap to the 4100. Call JD for pricing that is probably better than you...
Forum: Receivers, Amps, and Processors   12-13-2014, 05:25 PM
Replies: 4,417
Views: 201,277
Posted By batpig
Yeah, RCA from pre out to the input on the amp...

Yeah, RCA from pre out to the input on the amp just like you have it now. Only more of them. No need to change any settings on the receiver but re run Audyssey (or at least carefully level match)...
Forum: Receivers, Amps, and Processors   12-13-2014, 04:47 PM
Replies: 4,417
Views: 201,277
Posted By batpig
You're already running an external channel amp?...

You're already running an external channel amp? Just do the same thing you did already, but for 4 speakers instead of 2. The 4100 has 13.2 pre outs so you can externally amp as many channels as you...
Forum: Receivers, Amps, and Processors   12-13-2014, 01:04 PM
Replies: 4,417
Views: 201,277
Posted By batpig
It can. However, unlike the 5200, which has more...

It can. However, unlike the 5200, which has more flexible settings, it is mandatory that this first pair of externally amped channels is the Height2 outputs.

notice that none of the speaker...
Forum: Receivers, Amps, and Processors   12-13-2014, 12:59 PM
Replies: 4,725
Views: 537,170
Posted By batpig
And in terms of cons it would be features that...

And in terms of cons it would be features that have been added since this model was current (like networking). The best way to learn about these is to review the first few posts of owners threads in...
Forum: Receivers, Amps, and Processors   12-13-2014, 12:46 PM
Replies: 73,179
Views: 6,200,481
Posted By batpig
I think it's also worth noting in the FAQ that...

I think it's also worth noting in the FAQ that it's likely only to be an issue for people who listen at really loud volume as Mark notes in his explanation.
Forum: Receivers, Amps, and Processors   12-13-2014, 12:40 PM
Replies: 4,417
Views: 201,277
Posted By batpig
Under audyssey, there should be a section "amp...

Under audyssey, there should be a section "amp assign". It is also in the set up assistant, check under main speakers. Use you external to drive your mains.[/QUOTE]
No not on the 4100. See my post...
Forum: Receivers, Amps, and Processors   12-13-2014, 12:39 PM
Replies: 4,417
Views: 201,277
Posted By batpig
You're not missing anything. The X4100 doesn't...

You're not missing anything. The X4100 doesn't have the ability to do 9ch with only the front mains externally amped. You have to use external amps on the Height2 channels.

Just add a cheap two...
Forum: Speakers   12-13-2014, 09:02 AM
Replies: 52,802
Views: 3,906,122
Posted By batpig
+1 to the SVS suggestion. Those are the class...

+1 to the SVS suggestion. Those are the class leaders at the $500 price point. So then the question is just whether your prefer small size and sealed config or the larger size and greater ultra low...
Forum: Receivers, Amps, and Processors   12-13-2014, 08:58 AM
Replies: 73,179
Views: 6,200,481
Posted By batpig
I mentioned in my analysis that different people...

I mentioned in my analysis that different people may get different results, and I continue to advocate checking speaker levels using an external test tone source with Audyssey engaged. I do so...
Forum: Receivers, Amps, and Processors   12-13-2014, 08:56 AM
Replies: 73,179
Views: 6,200,481
Posted By batpig
bp, this is not what Mark Seaton explained (and...

bp, this is not what Mark Seaton explained (and measured) with MV above -10 dB setting.



And also this is not what Mark explained, but actually the opposite. Read his post, please.[/QUOTE]...
Forum: Speakers   12-12-2014, 04:29 PM
Replies: 52,802
Views: 3,906,122
Posted By batpig
There is no need to "match" a sub to the...

There is no need to "match" a sub to the speakers. As brendelac said those subs are definitely overpriced at face value.

You don't need a ton of subwoofage for a small bedroom, and I imagine you...
Showing results 1 to 25 of 5000

 
Forum Jump: