AVS | Home Theater Discussions And Reviews - Search Results
Showing results 1 to 25 of 399
Search took 0.05 seconds.
Search: Posts Made By: rush2049
Forum: Speakers   01-30-2015, 12:26 AM
Replies: 212
Views: 3,178
Posted By rush2049
Here are links to part 1 and part 2 of the final...

Here are links to part 1 and part 2 of the final mix from the last get together.

AVS 2014 12 06 Final G2G Mix Part 1.flac (http://1drv.ms/1uHWZS1)

AVS 2014 12 06 Final G2G Mix Part 2.flac...
Forum: Speakers   01-27-2015, 11:06 PM
Replies: 212
Views: 3,178
Posted By rush2049
How much should 3 outlets cost...with outlets in...

How much should 3 outlets cost...with outlets in same room as the fuse panel? Some nutcase quoted me $700, while some 'retired electrician' off craiglist wanted $150.[/QUOTE]

My run from breaker...
Forum: Speakers   01-27-2015, 12:25 PM
Replies: 212
Views: 3,178
Posted By rush2049
see above in bold

see above in bold
Forum: Speakers   01-27-2015, 11:28 AM
Replies: 212
Views: 3,178
Posted By rush2049
I wasn't actually going to bring my laptop /...

I wasn't actually going to bring my laptop / desktop this time. I was just going to host up a new FLAC for download and let you take care of playback.


If I am bringing the CX-15T's I don't have...
Forum: Receivers, Amps, and Processors   01-26-2015, 11:28 PM
Replies: 1,512
Views: 101,868
Posted By rush2049
I don't have this problem on my 3040. Is the...

I don't have this problem on my 3040.

Is the receiver powering the other zone and you are using pre-outs to your main speakers?
If so your wires are running too close to each other.....
Forum: Speakers   01-26-2015, 07:39 PM
Replies: 212
Views: 3,178
Posted By rush2049
I just got done running three dedicated 20 Amp...

I just got done running three dedicated 20 Amp lines through my house..... used up the last three breaker spots in the box.

Took me about 3 days after work each day to do.....
Forum: Speakers   01-24-2015, 01:52 PM
Replies: 1,463
Views: 50,593
Posted By rush2049
Its the high frequencies that make the CX-15T go...

Its the high frequencies that make the CX-15T go into a low resistance (near 3 ohm or lower even).

I have mine go into protect around 18khz at -20dB or 16khz if I have the main volume at -10 dB...
Forum: Receivers, Amps, and Processors   01-23-2015, 12:20 AM
Replies: 1,512
Views: 101,868
Posted By rush2049
I have an RX-A3040 and am experiencing a sudden...

I have an RX-A3040 and am experiencing a sudden shutoff due to over current. Does anyone know what the minimum ohmbrating the amps can handle? I am only seeing 8 and 6 ohm mentioned in the manual.......
Forum: Speakers   01-15-2015, 05:12 PM
Replies: 1,463
Views: 50,593
Posted By rush2049
1 inch down from the top of the tweeter cone, 2...

1 inch down from the top of the tweeter cone, 2 inches from the bottom
Forum: Speakers   01-15-2015, 03:29 PM
Replies: 1,463
Views: 50,593
Posted By rush2049
I have messed with various amounts of toe-in. The...

I have messed with various amounts of toe-in. The best sound stage for this small of space is no toe-in.

My capture equipment is a professional recording microphone (MXL v69 Mogami) through a Motu...
Forum: Speakers   01-15-2015, 01:21 PM
Replies: 1,463
Views: 50,593
Posted By rush2049
The room is not a theater room at all, its more...

The room is not a theater room at all, its more like a temporary cubby in a T shaped room. Not ideal at all. I also have power issues, but I won't get into that too much here.

I sit less than 5...
Forum: Speakers   01-15-2015, 01:04 PM
Replies: 1,463
Views: 50,593
Posted By rush2049
and I only sit 5 feet away.... :cool: Now, I...

and I only sit 5 feet away.... :cool:

Now, I only go that loud for some movies, usually I am 10 dB lower, lol.

I need more power if I want to run REW at reference, or adjust the gain on my...
Forum: Speakers   01-15-2015, 12:20 PM
Replies: 1,463
Views: 50,593
Posted By rush2049
I don't have an spl meter, so the scale on the...

I don't have an spl meter, so the scale on the left is only for relative relationships.

I also run things very loud.... I was probably up in the 110-120 dB range easily...... (as judged from my...
Forum: Speakers   01-15-2015, 12:15 PM
Replies: 1,463
Views: 50,593
Posted By rush2049
I can investigate... but I have no short circuits...

I can investigate... but I have no short circuits whatsoever for any other content playing in the past months.
Forum: Speakers   01-15-2015, 11:53 AM
Replies: 1,463
Views: 50,593
Posted By rush2049
Because it hit its current limit and shutoff. ...

Because it hit its current limit and shutoff.

If you look at the graph its correcting about 25dB of difference in output. I don't know what kind of power that requires... but its big, even though...
Forum: Speakers   01-15-2015, 10:49 AM
Replies: 2
Views: 44
Posted By rush2049
Without looking up the power handling of...

Without looking up the power handling of everything.....

The way you would wire it is, go from the stereo headphone jack to a cable that splits to RCA (red / white) then use two adapters to go...
Forum: Speakers   01-14-2015, 03:08 PM
Replies: 1,463
Views: 50,593
Posted By rush2049
A 'Perfect' speaker is one which would be equal...

A 'Perfect' speaker is one which would be equal volume (dB) across that graph. (A straight line)

A speaker is generally considered good if it is 1-3 dB swing across its entire range. The graph of...
Forum: Speakers   01-14-2015, 01:45 PM
Replies: 1,463
Views: 50,593
Posted By rush2049
I have been playing with the CX-15T's a bit...

I have been playing with the CX-15T's a bit today, finally broke out my professional microphone to measure it.

Now this graph I am posting, ignore the SPL numbers on the left.... as I do not have...
Forum: Area Home Theater Meets   12-28-2014, 05:52 PM
Replies: 1,073
Views: 17,333
Posted By rush2049
PoE is really good, the best parts about the game...

PoE is really good, the best parts about the game isn't the story really.... its playing in the new leagues (especially the hardcore one) and trying with buddies over and over again to try to...
Forum: Speakers   12-23-2014, 11:28 PM
Replies: 1,807
Views: 46,948
Posted By rush2049
Point taken. However, as for difficulty, I...

Point taken.

However, as for difficulty, I think the problem with multiple selectable HDMI inputs is the HDMI receiver chipset doesn't allow it. So, they'd have to purchase/license two, and...
Forum: Receivers, Amps, and Processors   12-23-2014, 03:26 PM
Replies: 1,512
Views: 101,868
Posted By rush2049
I just received my receiver..... :rolleyes: ...

I just received my receiver..... :rolleyes:

The Yamaha RX-A3040BL.

This is to replace my aging Onkyo TX-NR809 which had a few annoyances that had always bugged me.


After a quick 10 minute...
Forum: Area Home Theater Meets   12-19-2014, 08:51 AM
Replies: 1,073
Views: 17,333
Posted By rush2049
.....my cousin just went and saw the latest...

.....my cousin just went and saw the latest hobbit movie.....

He said it was awful and disappointing, the desolation of smaug was much much better...
I hope you guys aren't disappointed going to...
Forum: General Home Theater & Media/Game Rooms   12-19-2014, 08:43 AM
Replies: 2
Views: 477
Posted By rush2049
I decided to replace my aging Onkyo TX-NR809,...

I decided to replace my aging Onkyo TX-NR809, before the inevitable happens and the HDMI board fails.

So, after some consideration I am going to try the flagship Yamaha Receiver. The RX-A3040BL
...
Forum: Area Home Theater Meets   12-16-2014, 03:03 PM
Replies: 1,073
Views: 17,333
Posted By rush2049
This is also true...... have to have a...

This is also true......

have to have a common ground between all the equipment. Without it very odd and strange buzzing/whines happen.
Forum: Speakers   12-16-2014, 02:52 PM
Replies: 1,463
Views: 50,593
Posted By rush2049
jbrown15 I am curious what you are using to power...

jbrown15 I am curious what you are using to power the CX-15T's with.

I am currently only running them off of the Onkyo TX-NR809 (135 watts or so).
I checked the RMS rating on the site and it said...
Showing results 1 to 25 of 399

 
Forum Jump: