Posts by Massimo N

I had a similar issue where the EDID info on the 8700 was corrupted. At the time I used a registered version of Powerstrip to update the EDID info. I found an old post that explained the procedure. BENQ 8700+ EDID Issue

Quote: Originally Posted by Bob Pariseau That's correct. Typically I'll tell people to zero out ALL the volume trims in step 1 just because that's less confusing, but really only the LF and Sub trims (both Movie AND Music sub) are the...

Quote: Originally Posted by jayray It's a bug in ARC. It has been mentioned many times but don't worry, sometimes it's hard to wade through all the posts. John I was having trouble setting my levels to 75dB as well. Can you confirm...

Quote: Originally Posted by Selden Ball A more explicit answer: shorting two outputs together will most likely damage the output circuitry of both, allowing the "magic smoke" to escape. Thank you for the answer.

Quote: Originally Posted by sivadselim Are you recommending 'merging' the pre-outs with a Y-adapter? This is not a good idea. Y-adapters should only be used to split a signal, not merge. I am recommending merging the LF and RF...

My proposed solution is similar to RoboRay's. It looks like the 805 has pre-outs. In the receiver's config, just indicate you don't have a sub, and indicate that your main speakers are large. This will route all the .1 info to your...

I would suggest you look at getting a good quality HDMI switch that has auto switching. For you Audio switching, I would take a look at Audio Authority. I have used their Component switching unit a while back and was very happy with the...

I was wondering if anyone has the ASUS O!Play and has it successfully working with their AVM. I have the AVM30HD with ARC and running the 1.47f firmware. The AVM will only recognise 480p as a valid resolution, and I cannot force a...

Quote: Originally Posted by epiney I have a 8700 that just decided not to power up one day. Completely dead, no standby power when plugged in. I did a little research (not much as there was no way I was going to repair it) that would...

Just an update for those interested ... the new MX810 software (updated earlier this week) added Vista 64 support. Finally!! The program auto updates when you open it. I had to add the driver manually, but now Vista 64 recognizes the...