Posts by AustinJerry

OK, I see a 10dB difference in the 2KHz filtered graph at 8.5m, or a distance of 9.7ft.  Otherwise, the differences are much less significant.  

Quote: Originally Posted by jim19611961  If you had run 1 octave band studies before and after, you may have seen some difference that a fullband ETC wont show. I cant emphasize enough that looking at the fullband ETC...

Quote: Originally Posted by comfynumb  IMO the Marantz AV8801 does the DSD conversion to PCM better than than the Oppo 93 and according to a bud of mine the Marantz does it better than the 105. I've had my Oppo set to...

Gentlemen, I seem to be spinning my wheels when it comes to applying room treatments to improve my sound.   Back several days, I reported that I had removed some panels, replaced then with some new panels, and added a panel in...

Quote: Originally Posted by RapalloAV  I found this cheaper one from the same place, approx. $42 USD. Im sure this will do the trick to at least gain match all my subs, correct?...

Quote: Originally Posted by RapalloAV  That price is NZD so it is cheaper approx. $100 USD There was only one guy there on ebay who will ship to NZ and that was $45.00, more than the meter.   So, the...

Quote:Originally Posted by mathlete My apologies for asking a question that's probably been asked dozens of times before in one form or another. Currently I have a 4-5 year old Pioneer Elite, but don't care that much for MCACC. I...

Quote:Originally Posted by kbarnes701 Mark Seaton (of Seaton Submersive fame) agrees with and recommends that procedure. Mark knows a bit about subs You have to remove the effect of the room to gain match. Remember this isn’t...

Quote:Originally Posted by RapalloAV Guys would this meter be ok until my mic and meter arrives from the USA? It only goes down to 31.5Hz so Im not sure? http://www.jaycar.co.nz/productView.asp?ID=QM1589 That is quite expensive for...

Quote: Originally Posted by Selden Ball  I suspect it's because of the bi-amp setting. I've seen reports from other people here on AVS who've had similar calibration problems when bi-amping. Apparently there's a bug in...